Poulan 306 Specs

Poulan 306 Specs

The Poulan version 306A chain noticed become a portable, gasoline-engined machine for cutting wood outdoors. This chain saw, with its yellow-green and black colour scheme, turned into brought in 1970 by using Beaird-Poulan of Shreveport, Louisiana, and remained in manufacturing through 1980, when the model became discontinued. It weighed 12.seventy five pounds and became designed to be operated by using one man or woman. Poulan became a division of Emerson electric powered whilst this noticed become made however eventually have become a Husqvarna subsidiary.

This saws engine turned into a three.6-cubic-inch (59-cubic-centimeter), unmarried-cylinder, -cycle unit that ran at up to six,500 revolutions in keeping with minute on a mixture of fuel and oil from the built-in 18-fluid-ounce gasoline tank. The engine became manufactured from die-forged magnesium and aluminum components. The engine had a 1.79-inch bore and 1.forty four-inch stroke, as well as a reed-kind intake valve.

This Poulan noticed featured a breakerless, solid-state digital ignition that fired a Champion CJ8 spark plug with an opening set at zero.1/2 inch. It used a spark-arresting muffler, Tillotson carburetor and flocked wire-display screen air clear out, along side a rewinding guide pull starter.

The saws manual referred to as for a fuel-oil mix of sixteen:1, or eight ounces of -cycle oil in line with gallon of regular-grade fuel. but customers could run it on a 32:1 blend, or four ounces of oil consistent with gallon of gasoline, whilst using Poulan-emblem two-cycle engine oil. The fuel-oil blend lubricated the crankshafts caged-needle-roller and ball bearings and the chrome-plated cylinder walls.

Chain saw shoppers had a choice of sprocket-nosed manual bars for this version ranging in duration from sixteen inches to 24 inches. The chisel-kind chains for this noticed had a 3/8 inch spacing between the teeth. Poulan presented a preference of manual or automated chain oiling from an on-board chain-oil tank. proprietors could use unique bar-and-chain oil or SAE30W oil to lubricate the chain. The saw had a built-in automatic sharpener that executed 80 percent of the needed chain sprucing.

Source: here